drumvac off Firmware versions 1.00 and earlier: If the cable is detected, this command turns the drum vacuum pump off via the remote connection. Firmware versions 1.10 and later: If the drum vacuum pump is currently on and the drive level is non-zero, the system turns the drive level to zero, recalibrates the sensor, and sits in Ready state. If the pump is currently on and the drive level is 0 (i.e. Ready state), this command will turn the system off (i.e. turns off the cooling fan). When the system is in Ready state, the pump is on but not running. This means that the cooling fan is running. If the cooling fan is not turned off manually, it will turn off after approximately 10 mins of inactivity. ThermoFlex drumvac off

../commands/drumvac.xmlCommand: drumvac

../commands/drumvac_on.xmlCommand: drumvac on

../commands/drumvac_reset.xmlCommand: drumvac reset

../commands/drumvac_cal.xmlCommand: drumvac cal

..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:38:58 2008 PST